Ariens 920013 Service Campaign page 8

IMPORTANT: With the clutch lever engaged, the belt finger located opposite the belt idler must be less
than 1/8 in. (3.2 mm) from the belt, but not touching the belt, or belt grabbing may occur causing brush to
rotate while the attachment clutch is disengaged (Figure 9).
5. Adjust clutch (see Attachment Clutch/Brake Adjustment on page 5).
6. Replace belt cover and secure with cap screws.
7. Replace bottom cover and secure with cap screws.
8. Reinstall remote trigger cable to brush assembly.
9. Run in the attachment belt (see Run-in Attachment Belt on page 4).
10. Replace the belt cover.
1. Traction Belt Idler
2. Traction Drive Belt
3. Engine Sheave
4. Belt Finger
5. Attachment Drive Belt
6. Attachment Pulley
7. Attachment Idler Nut
8. Attachment Belt Idler
1. Belt Finger
2. Belt
11. Draw a check mark on the model/serial number label with an indelible black marking pen to signify
that the repair has been completed. See Figure 6.
Date: February 26, 2014
2
1
8
Figure 8
1
Figure 9
Page 8 of 8
No. C-2014R
Replaces C-2014
3
6
7
1/8 in. (3.18 mm)
(Maximum)
4
5
2