Fan - HP EliteBook 6930p Maintenance And Service Manual

Fan

Description
Fan
Before removing the fan, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the keyboard (see
6. Remove the switch cover (see
Remove the fan:
1. Disconnect the fan cable (1) from the system board.
2. Remove the Phillips PM2.5×7.0 screw (2) that secures the fan to the base enclosure.
3. Lift the front edge of the fan (3) until it rests at an angle.
4. Remove the fan (4) by sliding it forward at an angle.
Reverse this procedure to install the fan.
NOTE: To properly ventilate the computer, allow at least a 7.6-cm (3-inch) clearance on the left side
of the computer.
Battery on page 50).
Keyboard on page 65).
Switch cover on page 74).
Component replacement procedures
Spare part number
487436-001
77