Switch Cover - HP EliteBook 6930p Maintenance And Service Manual

Switch cover

Description
Switch cover (includes capacitative board and cable)
Capacitative board (includes cable)
Before removing the switch cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the keyboard (see
Remove the switch cover:
1. Close the computer and turn it upside down, with the rear panel toward you.
2. Remove the following:
(1) Two rubber screw covers. Screw covers are available in the Rubber Kit, spare part number
482966-001.
(2) Three Torx T8M2.5×7.0 screws.
(3) Two Phillips PM2.0×4.0 broad-head screws.
3.
Turn the computer display-side up, with the front toward you.
4.
Open the computer as far as possible.
74 Chapter 4 Removal and replacement procedures
Battery on page 50).
Keyboard on page 65).
Spare part number
486307-001
487428-001