Before You Begin; Layout Of The Camera; Quick Reference - Swann NHD-POE Series Instruction Manual

Before You Begin

Limited Warranty Terms & Conditions
Swann Communications warrants this product against defects in workmanship and material for a
period of one (1) year from its original purchase date. You must present your receipt as proof of date
of purchase for warranty validation. Any unit which proves defective during the stated period will be
repaired without charge for parts or labor or replaced at the sole discretion of Swann. The end user
is responsible for all freight charges incurred to send the product to Swann's repair centers. The end
user is responsible for all shipping costs incurred when shipping from and to any country other than
the country of origin.
The warranty does not cover any incidental, accidental or consequential damages arising from the use
of or the inability to use this product. Any costs associated with the fitting or removal of this product
by a tradesman or other person or any other costs associated with its use are the responsibility of the
end user. This warranty applies to the original purchaser of the product only and is not transferable to
any third party. Unauthorized end user or third party modifications to any component or evidence of
misuse or abuse of the device will render all warranties void.
By law some countries do not allow limitations on certain exclusions in this warranty. Where
applicable by local laws, regulations and legal rights will take precedence.
For Australia: Our goods come with guarantees which cannot be excluded under Australian
Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation
for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired
or replaced if the goods fail to be of acceptable quality and the failure does not amount to major
failure.
FCC Verification
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
• Consult the dealer or an experienced radio/TV technician for help
These devices comply with part 15 of the FCC Rules. Operation is subject to the following two conditions:
• These devices may not cause harmful interference, and
• These devices must accept any interference received, including interference that may cause
undesired operation.
Important Note:
All jurisdictions have specific laws and regulations relating to the use of cameras. Before using any
camera for any purpose, it is the buyer's responsibility to be aware of all applicable laws and regulations
that prohibit or limit the use of cameras and to comply with the applicable laws and regulations.
WARNING
Modifications not approved by the party responsible for compliance could void user's authority to
operate the equipment.
IMPORTANT SAFETY INSTRUCTIONS
• Make sure product is fixed correctly and stable if fastened in place.
• Do not operate if wires and terminals are exposed.
2
Introduction
Congratulations on your purchase of this Swann 720p Network Video
Camera with Power Over Ethernet. You've made a fine choice for keeping
a watchful eye over your home or business. The NHD-POE cameras
deliver brilliant and amazingly clear high definition images and videos in
both day and nighttime conditions even in complete darkness. Designed
in an elegant, unobtrusive weatherproof casing with an integrated
3-axis mounting bracket, the NHD camera is versatile enough to be
installed on walls and ceilings - indoors or outdoors and will be an
excellent addition to your Swann POE NVR monitoring solution.

Layout of the Camera

3
4
1 Mounting Bracket - Allows the camera to installed either on a wall or ceiling.
2
Camera Housing - Contains the camera, associated circuitry and electronic
components.
3
IR LEDs - These infrared LEDs are used by the camera to illuminate targeted areas
when in complete or near-total darkness.
4 Illumination Sensor - Detects the amount of incoming light and turns on the IR LEDs
for night vision when necessary.

Quick Reference

Default Camera Account Configuration
Username: admin
Password:
12345
1
2
3