Table of Contents
Advertisement
2.1.3
Setting Jumpers
There are jumpers on the system board of the F815D Series. You can
set the jumpers to make the necessary operations.
For any three-pins jumpers (Figure 6), the jumper setting is 1-2 when
the jumper connects pin 1 and 2. The setting is 2-3 when pin 2 and 3 are
connected and so on. You see one of the lines surrounding jumpers is thick,
which indicates pin NO.1.
To move a jumper from one position to another, use needle-nose pliers
or tweezers to pull the pin cap off the pins and move it to the desired
position.
Figure 6: Jumper Connector
11
Installations
Advertisement
Table of Contents
