Connecting The Drain Hose; Leveling Your Washer - Samsung WA456 Series User Manual

installing your washer

Connecting the drain hose

The end of the drain hose can be positioned in
three ways:
over the edge of a wash basin
Secure the guide to the side of the basin wall
with a hook or to the tap with a piece of string to
prevent the drain hose from moving.
In a standpipe or laundry tub
The standpipe must be no shorter than 39 in (99
cm) and no longer than 96 in (245 cm).
Make sure that the connection between the
drain hose and the standpipe is not airtight.
Connection the hose guide within 4 in (10cm)
from the end of the drain hose. If the drain hose is extended
more than 4 in (10cm) beyond the end of the hose guide, mold
or microorganisms could spread to the inside of the washer.
Drain Hose can be installed until 96 in (245cm) maximum. But
drain capability can be reduced at this height. It causes the
washer to have odor, because of remained water in the drain
system.
If drain hose is installed below 39 in (99cm), water can be
drained in cycle working cause of siphon phenomenon. It
causes the washer to "nF" error.
STEP 3

Leveling your washer

See if the washer is level by checking the position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour the water into the tub to
just below the pulsator level.
3. If the washer is level, the pulsator is positioned at the center of the
water as shown in the figure. If not, level your washer by turning the
front leveling feet clockwise or counterclockwise as necessary.
Turn the front leveling feet clockwise to raise the washer, and
counterclockwise to lower the washer.
16_ installing your washer
laundry tub
Hose
retainer
96" max
39" min
Tie
strap
Pulsator
loosen
Adjustable legs
Stand pipe
39" min
(99 cm)
lock