Table of Contents
Advertisement
INSTALLATION
ENVIRONMENT
Leave some space
Space at last 15cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2°)
Never install the washer near water.
Do not place the washer in steamy rooms or where
the washer is directly exposed to rain.
Moisture may destroy the electrical insulation and
cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
As plastic and electrical components are affected
by direct heat, never place the washer near heaters,
boilers,etc.
Do not place under direct sunlight.
CLEANING THE MACHINE
CLENING THE LINT FILTER
If the dregs are filled up in the lint filter after finishing
the wash, push down(1) and pull it out(2) as shown in
figure.
Remove the collected lint and rinse the filter net.
Lint Filter
CLEANING THE WASH TUB
Wipe off strains on the cabinet and operation panel with soft cloth.
Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush.
Painted surfaces or plastic parts will be damaged.
WT80J7-02206A_EN.indd 3
All manuals and user guides at all-guides.com
3
HOW TO CLEAN THE FILTER (In case drain pump)
1. Place a rag under the washer filter not to wet the
floor.
2. Rotate the filter counterclockwise and pull out
the filter.
3. Remove dirts and rotate the filter clockwise until
it locks in position.
Remark : Should be
cleaned Filter at least
1 time a week.
CONNECTING THE DRAIN HOSE
Insert the drain hose(a) and push it tighly to be
connected as arrow direction.
Install the drain hose about 70~80cm above the
ground for pump model.
OVERFLOW FILTER
Pull the upper side of the overflow filter
with two fingers into the hole 'A' in the
direction of arrow as shown in the figure.
Filter
Open
Close
Rag
(WITHOUT PUMP)
2006-02-17 ¿ÀÈÄ 2:43:19
Advertisement
Table of Contents
