Jabra Bluetooth Hub Setup - ReSound Azure User Manual

JABrA Bluetooth Hub setup

The JABRA Bluetooth Hub needs to be connected to the desk phone,
®
paired with the headset and configured to work with the correct type
of phone in order for the headset to work with the desk phone. Finally,
the sound quality can be fine tuned to give optimal sound without
any echo effect. These steps only have to be done once, and they are
explained in detail below.
The Bluetooth HUB is covered by a lid.
®
Use your finger nails to remove the
lid from the Bluetooth ® Hub.
This gives you access to settings
and allows you to see the symbols
above the connection sockets.
20
seTUP sTeP 1: Connecting your JABrA Bluetooth
and power supply
1. Disconnect the handset from your desk phone (by unplugging the
handset from the socket on the desk phone).
2. Connect the handset to the handset socket of your Bluetooth
3. Connect the desk phone socket port to the desk phone socket (15) on
the Bluetooth Hub. Use the supplied connection cord (desk phone-
®
to-Bluetooth ® Hub) for this.
4. Connect the power supply to the power supply of socket your Blue-
tooth ® Hub (18)
5. Connect the power supply to the wall power socket. When the LED
(10) is green, your Bluetooth ® Hub is now correctly connected to
your phone, and you can move on to "SETUP STEP 2: Pairing your
headset with the JABRA Bluetooth Hub" instructions.
In the unlikely event that the Bluetooth
will flash red.
• First, try disconnecting and reconnecting the Bluetooth
from the power source.
• If the LED is still flashing red, you must reset your Bluetooth
1. Press and hold the Bluetooth ®
2. The reset light (10) will turn solid red for 3 seconds, and then turn
green.
3. If the LED is still flashing red, after disconnect and reset, please
contact your dealer.
® Hub with desk phone
® Hub (14)
Hub is not OK, its LED (10)
®
® Hub
Hub.
®
Hub reset button (16).
21