3.
Press
/
to select the direction and press MODE/ENTER.
Only one Surface Fit setting will be stored so if you want to
change from the previous direction to the other, the notice
message will pop-up to remind you to reset the previous
Surface Fit setting.
4.
Press
/
to adjust the left or/and right side
convex or concave. Default is 0 and value is -40~0~40.
Single side adjustment is only for distortion.
5.
For both sides of the horizontal surface fit, use
adjust the center of the curve because it is not always at
the center. Default is 0 and value is -40~0~40.
6.
Press
/
to select Vertical Surface Fit and
press MODE/ENTER.
7.
Press
/
to select the direction and press
MODE/ENTER.
/
to
Operation
31