Registering An Additional Handset; Using Additional Handsets - BT BT4500 Quick Setup And User Manual

Using additional handsets

If you've bought a BT4500 multiple pack, any
additional handsets come pre-registered to the
base. However, if you purchase an additional
handset separately, you must register it to your
BT4500 base before it can be used.
Register an additional handset
1. Select , scroll
Menu
press .
OK
2. Press to display
3.
Register handset
4.
Press & hold 'Find Phone' on base
5. Press and hold
beep and the In use light starts to flash.
6. The handset will display
to indicate the base is in registration mode. If the
system PIN is not 0000 then you will be prompted
to enter it, then select
7. Once registration is successful the handset will show
Handset x registered
handset number). The handset will then synchronise
data with any other registered handsets, e.g. contacts,
speed dials and handset names.
If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
1666 BT4500 UG [5].indd 65
to display
Settings
and press
Registration
is displayed, press
OK
is displayed.
on the base until you hear a
Registering handset...
.
OK
(with X being the assigned
You can register up to five GAP
compliant handsets to your
BT4500 base to extend your
phone system without needing
to install telephone extension
sockets for each new phone.
If a handset becomes
un-registered it will need to be
registered to the base again.
and
Please register this handset will
be displayed, select
.
follow the instructions starting
OK
from point 4 below.
.
You have 2 minutes to complete
the registration process. After 2
minutes the In use light on the
base will stop flashing.
If registration isn't successful
the first time, please try again
incase the base registration
period ran out of time.
If there are already five
handsets registered to the
base, the registration will fail.
You must de-register another
handset before you can register
the new one.
65
then
OK
09/04/2013 15:04