JBL VT4889ADP User Manual page 26

Protective Jackets for Input and AC Power Modules
Each V T Series system is supplied with a pair of protective jackets that are designed to fit snugly
ER EC
onto the input and AC power modules of the DP or DP1 electronics assembly. These jackets are made of
reinforced, weatherized nylon fabric with Velcro attachment strips and drawstrings to secure the opening
once installed. They can be used by the system operator or installer to provide a degree of protection from
dirt, dust, and moisture and to protect cables and connectors.
Protective Jacket Installation
Complies with IEC 6059 - IPX-, not evaluated for outdoor use.
1. R emove two protective jackets from the protective jacket kit. To
install, open the jacket by "unzipping" the Velcro strip and locate
two smaller Velcro tabs on the inside of the jacket. See Figure 1
. Open the center Velcro tab and insert through the opening in the
module riser. See Figure 2
. N ext, wrap the left side of the cover around the bottom edge of
the riser. Insure that the bottom of the jacket is tucked into the
riser ring crevice between the top of the chassis and the bottom
of the riser ring rim. See Figure 3.
. P ull the second Velcro tab through the second opening in the
riser ring. See Figure 3
6
V T User's Guide
ER EC
Figure 1
Figure 2
Figure 3