Changing The Fuse In The Vehicle Power Cable; Mounting On Your Dashboard - Garmin nüvi 2405 Series Owner's Manual

Changing the Fuse in the Vehicle
Power Cable
NOTICE
When replacing the fuse, do not lose any of the
small pieces and make sure they are put back in
the proper position. The vehicle power cable
does not work unless it is assembled correctly.
If your device does not charge in your vehicle,
you may need to replace the fuse located at the
tip of the vehicle adapter.
1
Unscrew the end piece
TIP: You may need to use a coin to remove
the end piece.
2
Remove the end piece, the silver tip
, and the fuse (glass and silver
➋
cylinder) .
➌
3
Install a 1 A or 2 A fast-blow fuse.
66
.
➊
➊
➋
➌
NOTE: The required fuse for your cable
is listed after "output" on the back of the
vehicle power adapter.
4
Place the silver tip in the end piece.
5
Screw the end piece back into the vehicle
power cable.

Mounting on Your Dashboard

NOTICE
The permanent mounting adhesive is extremely
difficult to remove after it is installed.
Use the enclosed mounting disk to mount your
device to the dashboard and comply with certain
state regulations.
1
Clean and dry the dashboard where you are
placing the disk.
2
Remove the backing from the adhesive on
the bottom of the disk.
3
Place the disk on the dashboard.
nüvi 2405/2505 Series Owner's Manual