Installation Guide; Unit Connections And Features; Rednet 3 - Front Panel - Focusrite RedNet 3 User Manual

INSTALLATION GUIDE

Unit connections and features

RedNet 3 - Front Panel

1. AC Power switch
2. AES ACTIVITY – four green LEDs which illuminate when a valid AES/EBU digital audio signal
is present at the corresponding AES/EBU input. A further set of four indicates the presence
of a signal at each of the AES/EBU outputs. Note that the numbering is in pairs, as one
AES/EBU signal (input or output) corresponds to two audio channels.
3. ADAT ACTIVITY – two sets of four green LEDs which illuminate when a valid digital audio
signal in ADAT format is present at the corresponding input or output TOSLINK port. Note
that as one port (input or output) can carry 8 channels of audio at a sample rate of 44.1 or
48 kHz, but correspondingly less at higher sample rates, the number of LEDs which will be
active is dependent both on the number of ports in use and the sample rate.
4. NETWORK status flags – two green LEDs confirming network status:
• CONNECTED – illuminates when the unit is connected to an active Ethernet network
• LOCKED – illuminates when a valid clock sync is received via the network or an external
source
5. SAMPLE RATE indication – five yellow LEDs; only one of these (44 .1 kHz, 48 kHz, 88 .2 kHz,
96 kHz, 192 kHz) will be lit at a time, to confirm the sample rate that the system is running at.
4
5
6
2 3 1
7