Acura 2001 CL Owner's Manual page 258

Replacing Front Turn Signal/
Parking and Side Marker Light
Bulbs
1. If you are changing the bulb on
the driver's side, start the engine,
turn the steering wheel all the way
to the right, and turn off the
engine. If you are changing the
bulb on the passenger's side, turn
the steering wheel to the left.
H H O O L L D D I I N N G G
C C L L I I P P S S
2. Use a flat-tipped screwdriver to
remove the two holding clips from
the inner fender.
3. Pull the inner fender cover away
from the fender and bumper.
4. Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
5. To remove the front turn signal/
parking light bulb, push it in
slightly and turn it
counterclockwise. To remove the
side marker bulb, pull it straight
out of its socket.
6. Install the new bulb into the
socket.
Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
7. Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
8. Test the lights to make sure the
new bulb is working.
9. Put the inner fender in place.
Install the two holding clips. Lock
each clip in place by pushing on
the center.
Maintenance
Lights
255