Diagnostic Beep Codes - Dell Vostro 1440 P22G Owner's Manual

Diagnostic Beep Codes

The computer may emit a series of beeps during start-up if the display cannot show
errors or problems. These series of beeps, called beep codes, identify various problems.
The delay between each beep is 300 ms, the delay between each set of beeps is 3
seconds, and the beep sound lasts 300 ms. After each beep and each set of beeps, the
BIOS should detect if the user presses the power button. If so, BIOS will jump out from
looping and execute the normal shutdown process and power system.
Code
1
2
3
4
5
6
7
8
Cause and Troubleshooting Steps
BIOS ROM checksum in progress or failure
System board failure, covers BIOS corruption or ROM error
No RAM detected
No memory detected
Chipset Error (North and South Bridge Chipset, DMA/IMR/
Timer Error) , Time-Of-Day Clock test failure , Gate A20 failure ,
Super I/O chip failure , Keyboard controller test failure
System board failure
RAM Read/Write failure
Memory failure
Real-time clock power fail
CMOS battery failure
Video BIOS test failure
Video card failure
Processor failure
Processor failure
Display
Display failure
25
73