Table of Contents
Advertisement
Chapter 3
Installing the AVS 3120
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
•
•
•
This section contains the following procedures:
•
•
Attaching a Two-Post Rack Bracket to the AVS 3120
You may install the AVS 3120 in either a four-post rack or a two-post rack by using the two-post rack
brackets included in the accessory kit. Follow these steps:
1.
OL-11805-01
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in
the rack.
Statement 1006
Attaching a Two-Post Rack Bracket to the AVS 3120
Installing the AVS 3120 on a Workbench or Tabletop
Place the right-hand bracket on the right side of the AVS 3120, as shown in
bracket with the screw holes in the AVS 3120, and use two round head screws to secure the bracket.
Repeat this step to attach the left-hand bracket to the AVS 3120. Note that the brackets are different.
Cisco AVS 3120 Application Velocity System Hardware Installation Guide
Installing Your AVS 3120
Figure
3-1. Align the
3-3
Advertisement
Table of Contents
