Cisco AVS 3120 Hardware Installation Manual page 11

Chapter 3 Installing the AVS 3120
You can view the DNS settings by using the show dns command:
velocity>show dns
PRIMARY NAMESERVER 10.68.226.120
SECONDARY NAMESERVER 10.68.226.121
Configure the local time zone with the set date tz command:
Step 5
velocity>set date tz timezone
where:
timezone
city/time zone names, use the command show timezone all. The default time zone is America/Tijuana.
You can view the current time zone setting by using the show timezone current command:
velocity>show timezone current
America/Tijuana
Step 6 Configure the initial date and time setting. You can do this automatically by synchronizing to a network
time protocol (NTP) server, or manually by using the set date time command. To use an NTP server, use
the set ntp command, as follows:
velocity>set ntp start ip
where:
start
is the NTP server IP address or fully qualified domain name, such as 10.68.226.100 or time.nst.gov
ip
You can view the NTP settings by using the show ntp command:
velocity>show ntp
STATUS: RUNNING
NTP SERVER:
If you would rather manually set the time, use the following command:
velocity>set date time MM:DD:hh:mm:YYYY
where
You can view the time and date by using the show date command:
velocity>show date
Wed Dec
TimeZone=America/Tijuana
Note
Configure the system host name with the set hostname command:
Step 7
velocity>set hostname name
where:
is the system host name, such as velocity2
name
You can view the host name setting by using the show hostname command:
velocity>show hostname
velocity
OL-11805-01
is the local city/time zone name, such as America/New_York. To see a list of available
can be , to start using NTP, or
start
time.nist.gov
is month:day:hour:minute:year
MM:DD:hh:mm:YYYY
7 19:10:04 2005
You must set the accurate date and time for the appliance to function properly.
Cisco AVS 3120 Application Velocity System Hardware Installation Guide
, to stop using NTP
stop
Configuring Network Settings
3-11