Table of Contents
Advertisement
Viewing and Updating the Software Image on the
Chassis
Topspin-360# show card-inventory
================================================================================
================================================================================
used-memory : 77040 (kbytes)
free-memory : 50272 (kbytes)
used-disk-space : 45048 (kbytes)
free-disk-space : 57331 (kbytes)
last-image-source : TopspinOS-2.0.0/build495
primary-image-source : TopspinOS-2.0.0/build495
fpga-firmware-rev : 6
ib-firmware-rev : 200000000
used-memory : 47676 (kbytes)
free-memory : 34948 (kbytes)
used-disk-space : 8909 (kbytes)
free-disk-space : 33361 (kbytes)
last-image-source : TopspinOS-2.0.0/build495
primary-image-source : TopspinOS-2.0.0/build495
<output truncated>
View the Software Image Version with the CLI
1.
To view the primary software image version for all cards in the chassis, use the show
card-inventory command. Look for the primary-image-source field for each slot. (The slots are
described in
Figure
2.
Note that it is possible to have different versions of software installed on different slots. To update
an individual Fibre Channel or Ethernet Gateway, perform the steps as described here, but you do
not need to reboot the chassis. After the copy and installation, you can enable and disable an
individual gateway to activate the new image.
Example
Card Resource/Inventory Information
slot-id : 1
image : TopspinOS-2.0.0/build495
cpu-descr : PPC 440GP Rev. C - Rev 4.129 (pvr 4012 0481)
slot-id : 10
image : TopspinOS-2.0.0/build495
3.
To view all existing boot images that exist on the chassis (whether or not they are currently being
used), use the dir image command.
A .img file is an image file that is not installed.
1-2.)
33
Advertisement
Table of Contents
