Related Documentation; Translated Safety Warnings - Cisco CATALYST 6500 WS-X6066-SLB-S-K9 Installation Note

Catalyst 6500 series switch content switching module with ssl

Table of Contents

To understand the Cisco IOS command-line interface and Cisco IOS command modes, refer to

Chapter 2, "Command-Line Interfaces," in the Catalyst 6500 Series Switch Cisco IOS Software

Configuration Guide.

To understand the Catalyst operating system command-line interface and Catalyst operating system

command modes, refer to Chapter 2, "Command-Line Interfaces," in the Catalyst 6500 Series Switch

Configuration Guide.

Unless your switch is located in a fully trusted environment, we recommend that you configure the

module through a Telnet connection using Secure Shell (SSH) encryption.

You can session into the module from the switch console and configure the CSM-S. The session is a

Telnet interface through the Ethernet out-of-band channel (EOBC) of the switch backplane.

You can also make a Telnet connection into the module from a specified host and on a specific interface.

Telnet support for this host should be configured or enabled from the module console.

Console output is redirected to all active Telnet sessions. When no Telnet session is available, the output

is saved to a buffer. The buffer output can be subsequently examined when you make a Telnet connection

into the module.

Chapters

Table of Contents