Warnings and Precautions • CAUTION: TO PREVENT ELECTRIC SHOCK, • WARNING: Shock hazard - Do Not Open. MATCH WIDE BLADE OF PLUG TO WIDE SLOT, • AVIS: RISQUE DE CHOC ÉLECTRIQUE - NE PAS FULLY INSERT. OUVRIR • WARNING: To reduce the risk of fire or electric shock, Mains Plug or Direct plug-in adapter is used as disconnect do not expose this apparatus to rain or moisture.
Important Safety Instructions Read these Instructions. FCC Warnings Keep these Instructions. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance Heed all Warnings. could void the user’s authority to operate the equipment. Follow all instructions. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Do not use this apparatus near water.
Bluetooth Dock and Speakers Features Included • Plays and charges docked • Remote control: requires a iPod, iPhone, and iPad CR2025 battery (pre-installed) • iPad authentication IC • Component video cable • iPod, iPhone, and iPad controls • AC/DC power adapter •...
Introduction Release Power Dock for iPod, Adjust to release Press to turn the iPhone or iPad the dock from a unit on or off. locked position. RELEASE POWER SOURCE VOLUME PAIR Pair/Play/Pause Source Skip/Search Volume Press to switch Press to skip between Press and hold to Press to adjust begin connecting a...
Page 7
Mute Power Source Press to mute Press to turn the Press to switch the volume. unit on or off. between Line in, iPod and Menu Bluetooth modes. Press to access MUTE SOURCE Enter the menu. Press to make MENU ENTER Play/Pause a selection.
Setup Power DC power input: requires an AC/ DC power adapter (included) SPEAKER Pb/Cb Pr/Cr LINE IN DC IN 13V Remote CR2025 Remote control: requires 1 CR2025 battery (pre-installed) OPEN WARNING: The remote control’s button cell battery contains mercury. Do not put in the trash, instead recycle or PUSH dispose of as hazardous waste.
iPod and iPhone Docking an iPod, iPhone or ipad Connect the iPod or iPhone to the connector inside the Dock for iPod, iPhone or iPad. RELEASE If the connector has been moved into a downward locked position, slide the Release latch POWER SOURCE VOLUME...
Bluetooth Setup Pairing a Bluetooth Device Power on the unit by pressing the Power button. RELEASE Press the Source button to switch to Bluetooth Mode. Press and hold the Pair button. POWER SOURCE VOLUME The Pairing Indicator will flash blue PAIR and a voice will say “Speaker is Pairing”.
Video output and Line in Using the Component Video Output Using the 3.5mm Audio Input The Component Video Output Requires a 3.5mm audio cable will only output video from a (not included) docked iPod, iPhone or iPad. Connect a 3.5mm audio cable Connect a component video cable to the Line In on the speaker (not included) to the Component...
Company Information International Support Green Initiative To download this User’s Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit the support section at www.iLiveElectronics.com. Para descargar este Manual del Usuario en inglés, español y francés, o para obtener respuestas a preguntas frecuentes, visite la sección de apoyo Environmental Commitment to ‘Protect...
Need help?
Do you have a question about the ISDB752B and is the answer not in the manual?
Questions and answers