Heat & Glo XLR-PB-CE Owner's Manual page 61

B. Vent Components Diagrams (continued)
Note: Heat shields MUST overlap by a minimum of 3,8 cm. The heat shield is designed to be used on a
wall 10,2 cm to 18,4 cm thick. If wall thickness is less than 10,2 cm the existing heat shields must be
field tricmed. If wall thickness is greater than 18,4 cm a DVP-HSM-B will be required.
38,4 cm
30,5 cm
20,6 cm
38,1 cm
Figure 17.5 SLP Series Vent Components
20,3 cm
SLP-TRAP
Horizontal Termination Cap
33,0 cm
HORIZONTAL TERMINATION CAP
Heat & Glo • XLR-N-CE, XLR-PB-CE • 2198-900 Rev. J • 5/12
Heat
Shield
Term Cap
Max
Trap1
Effective
Length
Trap2
Effective Length
14,6 to 21,3 cm
14,0 cm
87°
SLP-HRC-SS
SLP-HRC-ZC-SS
Minimum Maximum
Effective Length Effective Length
7.9 cm 12,1 cm
13,3 cm 23,5 cm
21,3 cm
3°
26,7 cm
27,6 cm
61