Harris DAC-5016 Installation And Operation Manual page 40

Chapter 2: ADC-5100 Series Analog Digital Clocks
Repositioning the Hands
Setting the Time in Master Clock or Stand Alone Modes
Local Time Offsets
28
• +
CCW MANUAL SET
second hand position in counter-clockwise direction for precise
tracking during normal operation (non-Manual Set Mode).
To reposition the clock hands, follow these steps:
1. Enter the Manual Set Mode by pressing and holding the
button until the hands come to a complete stop and the error
SET
LED at the bottom of the clock face is illuminated.
2. The button advances the hands clockwise by one second each
CW
time it is pressed. If the
accelerate until full speed is reached (after about 30 seconds). To
stop the hands, re-press the
3. The button causes the hands to move counter-clockwise.
CCW
When pressed once, the hands move backwards 50 seconds. If the
button is held down, the hands accelerate until full speed is
CCW
reached. To stop the hands, re-press the
To set the time in Master Clock or Stand Alone modes, follow these
steps:
1. Follow the steps described in
2. Stop the hands a little after the real time and wait for the precise
moment to start the clock.
3. Press and hold the
one second before the correct time to ensure proper synchronization
with the time of day. The clock will start normally.
The clock hands may be electronically repositioned to provide a local
offset from the input timecode. This is particularly useful for displaying
multiple time zones from the same timecode source. There are a number
of methods to achieve this and the simplest is described below.
5000/5100 Series Digital Analog Clocks Installation and Operation Manual
Pressed together, these buttons move
button is held down, the hands
CW
button.
CW
CCW
"Repositioning the
button. Release
MANUAL SET
MANUAL
button.
Hands".
MANUAL SET