Powering The Recorder; Installing An Sd Card - Zoom H2next Operation Manual

Powering the recorder

1.
Turn the power OFF , and then remove the battery cover.
2.
Insert batteries.
3.
Close the cover.
NOTE
∙ Use alkaline or nickel-metal hydride batteries.
soon and put in new batteries.
∙ Set the type of battery used. (➝P .18)
1.
Connect the cable to the USB port.
2.
Plug the adapter into a power outlet.
12
Press here
and slide down

Installing an SD card

1.
After turning the power OFF , open the SD card slot cover.
2.
Insert the card into the slot.
To remove a card, push it further into
the slot and then pull it out.
NOTE
∙ Always turn the power OFF before inserting or removing an SD card. Doing so
when the power is ON could cause data to be lost.
∙ Be sure to insert the SD card correctly, using the cut-off corner illustration next
to the slot as a guide.
∙ The built-in memory will be used if no SD card is in the recorder.
∙ Format the SD card if necessary. (➝
HINT
Built-in memory
∙ The built-in memory only keeps the most recent recording.
∙ Recording time is limited to 1 minute.
∙ Recordings saved to the built-in memory cannot be copied to an SD card or a
computer.
H2n
Handy Recorder
13