Planet WNL-U553 User Manual page 38

3.All access points found will be displayed. Please make sure the access point you wish to
connect is displayed. If not, please click 'Rescan' few more times. You can also click
'Information' button to see the detailed information about selected access point.
4.Click 'PBC' button now to start to establish wireless connection by WPS, and please be
patient (This may require several seconds to one minute to complete). When you see 'WPS
status is connected successfully' message, it means the connection between your WNL-U553
and access point is successfully connected by WPS, and the information about access point
you connected to will be displayed.
Sometime WPS may fail, and you can click 'PBC' button few more times to try again. When an
access point is connected, you can click 'Disconnect' to disconnect your wireless network card
from a connected access point, or select another WPS-enabled wireless access point, then
click 'Connect' to establish connection to selected access point, if there are more than one
WPS-enabled access point found. You can also click 'Rotate' button, and next access point on
the list will be selected to establish connection.