Husqvarna HUV 4213-GXP Owner's Manual page 33

OIL FILTER
DRAIN PAN
9. Place a floor jack under the rear receiver hitch where the hitch and body frame are fastened. Lift the vehi-
cle body slightly, allowing the front of the engine to tilt slightly downward. This will allow the oil filter more
clearance under the electrical component box (Figure 19).
10. Relocate the oil drain pan to a position under the engine oil filter (Figure 18).
11. Remove the engine oil filter, turning it counterclockwise, allowing the residual oil in the filter port and filter
to drain into the oil drain pan (Figure 20). See following NOTE.
SNUBBER
BRACKET
Figure 19 Compress Snubber Downward
Figure 18 Engine Oil Drain Plug and Pan
Compress
down.
SNUBBER
2007 HUV4213 Gasoline Vehicle Owner's Manual
DRAIN PLUG
OIL DRIP GUARD
DRAIN PAN
Figure 20 Remove Engine Oil Filter
Engine Oil
USED OIL FILTER
Page 31