Operation - Southbend RS-4E Owner's Manual

PERFORMANCE CHECK:
The following items should be checked before or within the first 30 days of operation by a qualified service technician.
1. Check doors for proper alignment.
2. Check door gaskets for wear and sealing ability.
3. Check spray tubes or nozzles for cleanliness and/or leakage.
4. Check all gauges, timers, valves and switches for proper operation.
5. Visually check control compartment wiring for burned or loose connections.
6. Check electrical load on elements for proper wattage.
7. Be sure operators understand importance of proper cleaning and maintenance.
BE SURE ALL OWNERS MANUALS, WARRANTY INFORMATION, AND IMPORTANT
PAPERS ARE GIVEN TO THE PROPER AUTHORITY.
THEORY OF OPERATION:
Compared to other steam cookers with complicated boilers, the RS-4E is a very simple machine. Immersion elements
are installed on the left side of the cavity and when water covers the elements, water starts to boil and turn to steam.
There is no pressure in this unit.
The Steammaster RS-4E is designed to provide quick heat-up from a cold start. The RS-4E also utilizes an "Idle" system
that conserves energy, while keeping the unit ready during low use periods.
All equipment must be installed correctly to ensure proper operation and reliable service. Installation instructions must
be followed by a qualified technician.
Before you turn the unit on, be sure that you have: POWER to unit, WATER to unit, and an OPEN DRAIN.
CONTROL OPERATIONS
STARTUP:
1. Turn power switch on. Unit will fill quickly and begin heating. Unit will be up to operating temperature, ready to
use, in approximately four (4) minutes. The "Ready" light will light up when the unit is ready to use.
2. Start up may be initiated in any of the timer settings. "Man, Idle," or a "Set" time.
A. In "Idle" mode the unit will start up full power and go into Idle mode automatically when the ready light
comes on.
NOTICE
INSTALLATION

OPERATION

PAGE 7