Finish Operation - Kärcher VC 6200 Instructions Manual

Figure 7a
The power suction adjustment is at the
power suction control:
- Marking MAX, high power suction
- Marking MIN, low power suction
Note: the marking shows the current
suction power.
Figure 7b
If the suction power of the appliance is set
too high, the suction nozzles can vacuum
with much greater force on carpets, uphol-
stery and curtains.
Use the manual vacuum slide to reduce
the suction power. Close it again after
use.
Suction using accessories
Changing the attachments in the
QuickClick attachment housing
Hang the floor nozzle on the backside of
the appliance into the parking holder,
and push into the pause position.
Figure 8
Push the dead button at the handle and
remove the telescopic suction pipe.
Figure 9
Open the attachment housing cover.
Figure 10
Insert the handle in the desired accesso-
ry until the stop. It then gets locked.
Then tilt it downwards and pull it out.
Figure 11
To store, put the attachment using the
handle into the attachment housing and
click it up into place. Remove the handle.
Notice: You also can remove the attach-
ment manually and put it on top of the
handle. In order to release the attach-
ment, push the dead button on the han-
dle.
Notice: All steps stated above can also
be done when the telescopic suction
pipe is connected. Hang the floor nozzle
on the backside of the appliance into the
parking holder, and push into the pause
8
English
position. Pull the telescopic suction pipe
straight up.
ComfoGlide nozzle
Figure 12
Carpets and wall-to-wall carpeting:
Select the knob position as follows:
Reducing the power of the pusher, select
the knob position as followns:
Figure 13
Hard areas:
Select the knob position as follows:

Finish operation

Figure 14
Push the take-up cable button. The cable
will pull itself automatically into the appli-
ance.
Hang the floor nozzle on the backside of
the appliance into the parking holder,
and push into the pause position.