Front/Rear Axle Fluid - Jeep Grand Cherokee 2013 Owner's Manual

634 MAINTAINING YOUR VEHICLE
WARNING! (Continued)
• To avoid contamination from foreign matter or
moisture, use only new brake fluid or fluid that has
been in a tightly closed container. Keep the master
cylinder reservoir cap secured at all times. Brake
fluid in a open container absorbs moisture from the
air resulting in a lower boiling point. This may
cause it to boil unexpectedly during hard or pro-
longed braking, resulting in sudden brake failure.
This could result in a collision.
• Overfilling the brake fluid reservoir can result in
spilling brake fluid on hot engine parts, causing
the brake fluid to catch fire. Brake fluid can also
damage painted and vinyl surfaces, care should be
taken to avoid its contact with these surfaces.
• Do not allow petroleum based fluid to contaminate
the brake fluid. Brake seal components could be
damaged, causing partial or complete brake failure.
This could result in a collision.

Front/Rear Axle Fluid

For normal service, periodic fluid level checks are not
required. When the vehicle is serviced for other reasons the
exterior surfaces of the axle assembly should be inspected.
If gear oil leakage is suspected inspect the fluid level. Refer
to "Fluids, Lubricants, and Genuine Parts" in "Maintaining
Your Vehicle" for further information.
Front Axle Fluid Level Check
The front axle oil level needs to be between 1/8 in (3 mm)
(Continued)
below the bottom of the fill hole and the bottom of the fill
hole.
WARNING! (Continued)