This outlet must be fused and should not be controlled by the same wall switch that operates a food straighten the copper tubing. waste disposer, unless you have a SinkTop Switch ™ from InSinkErator ® ■ If you suspect elevated levels of chlorine in your water, it is recommended to use our water filtration system.
START HERE INSTALLING THE FAUCET PROPER INSTALLATION SHOULD TAKE ABOUT 2-4 HOURS PREPARATION Unpack faucet components. Identify locations for the faucet and Required minimum from On a firm, flat surface, carefully tank. straighten the copper tubing. center of hole to wall Check to make sure there is proper "...
Page 4
MOUNTING THE TANK FINAL WATER CONNECTION Select a spot under the sink to mount It is recommended that the water tank vertically within reach of both connection be made using a shutoff valve (not supplied). Tank must be plumbing and electrical connections. mounted level The tank should be within 16"...
A drain pan, plumbed to an appropriate contact an authorized InSinkErator service agent to replace or repair the unit in your home at of the plastic components and void the drain or outfitted with a leak detector, no cost to you.
Please read Troubleshooting Guide and/or visit www.insinkerator.com before calling AnswerLine ™ TROUBLESHOOTING PROBLEM POSSIBLE CAUSE WHAT TO DO Water and steam spits • Water is boiling in storage tank. • Lift faucet lever to release some water from forcefully from spout the tank.
Need help?
Do you have a question about the Ultra System and is the answer not in the manual?
Questions and answers