Table of Contents
Advertisement
LARDER FRIDGE - MODELS RLA31,RLA33,RLM31,RLM33
INSTRUCTIONS FOR INSTALLATION & USE
GETTING STARTED:
STEP 1
Choose a location for your
fridge, away from any
heat sources and
allow adequate
ventilation - 30mm
(1
/
inch) gap above.
1
4
STEP 3
Level the fridge by
adjusting the front feet.
This will stop rocking or
vibration and keep the
door aligned.
STEP 5
Plug in and switch on.
Allow the fridge to cool
before placing food
inside.
All food in the fridge
should be covered.
Read the rest of these instructions to get the best from your appliance
and remember to fill in your guarantee registration.
To ensure that your fridge runs reliably and efficiently follow these steps.
Keep this Book in a safe place for quick reference.
STEP 2
Move the fridge into
position, using the sides
of the cabinet. Take care
to avoid damaging the
refrigerant circuit pipe
work on the rear.
STEP 4
Before plugging in and
switching on, leave the
fridge in its final
location for at least 15
minutes to allow it to
settle.
STEP 6
Your fridge is now
working.
If after 24 hours your
fridge is not operating as
you want, refer to the
Troubleshooting section.
Advertisement
Table of Contents
Related Manuals for Hotpoint RLA31
Summary of Contents for Hotpoint RLA31
- Page 1 LARDER FRIDGE - MODELS RLA31,RLA33,RLM31,RLM33 INSTRUCTIONS FOR INSTALLATION & USE GETTING STARTED: To ensure that your fridge runs reliably and efficiently follow these steps. STEP 1 Choose a location for your fridge, away from any heat sources and allow adequate ventilation - 30mm inch) gap above.
-
Page 2: For Your Safety
For your safety, read the following advice: The fridge cooling system contains a small amount of gas which is environmentally friendly but flammable. To avoid any risk :- Install the fridge following the installation instructions and ensure that ventilation openings are kept clear of obstruction. Take care when installing or moving the fridge to avoid damaging the pipes on the rear. -
Page 3: Installation
Location & Air Circulation Locate your fridge away from sources of heat e.g. cookers, radiators, direct sunlight as extreme temperature will affect its performance. Allow a minimum 30mm (1 the fridge and the underside of the worktop. Providing you follow the recommended ventilation requirements you will :- Prolong the life of the fridge. - Page 4 15 minutes to allow it to settle. Fitting a Fridge under a Work Top To minimise running costs Hotpoint recommend fitting a vent to the rear of your worktop, which is available from Hotpoint Genuine Parts & Accessories Mail Order Hotline (see KEY CONTACTS, back page).
- Page 5 This fridge is fitted with a special mains lead. If you need to replace the mains lead due to damage, one can be bought from Hotpoint Service (see KEY CONTACTS, back page). It is strongly advised that this work is carried out by a qualified electrician.
- Page 6 Anti-clockwise (lower number) - Warmer You can check the temperature of the fridge compartment by using a Fridge Freezer Thermometer available from Hotpoint Genuine Parts and Accessories Mail Order Hotline (see KEY CONTACTS back page). WARNING: Do not use a mercury filled thermometer, as breakage would cause a health hazard.
-
Page 7: Storage Zones
Useful Advice Note: The Rating Plate, which lists the appliance Model Number and Serial Number can be found near the bottom of the left hand internal wall. STORAGE ZONES Zone Type Food Storage Cool Dairy products, Cheese, butter, margarine, Low fat spreads, cooking fats / lards Preserves - Jam, curd, marmalade, spread, salad dressing or sauces. - Page 8 Microban® technology has been proven safe, durable and effective over many years of use in personal care and household consumer products. In addition, Hotpoint operate a rigorous antibacterial testing programme through approved independent testing laboratories.
- Page 9 Advice on Adjusting Shelves Make the most of the interior storage space by repositioning shelves to suit the various heights of individual items you wish to store. To remove, ensure that the door is open fully. Slide the shelf forward and tilt from position. Salad Bins For the storage of fruit, vegetables and salad items.
-
Page 10: Defrosting And Cleaning
Defrosting and Cleaning No manual defrosting required The fridge compartment will defrost automatically. During defrost periods water droplets form on the interior back wall of your Larder Fridge and refreeze afterwards. Note : if your kitchen becomes exceptionally warm, your Larder Fridge may not defrost regularly. - Page 11 Changing the Light Bulb WARNING: Switch off at socket outlet and pull out the mains plug Obtain a replacement SES 15W bulb from the Hotpoint Genuine Parts and Accessories Mail Order Hotline (see KEY CONTACTS back page) and fit as follows : Remove any shelves from directly below the interior light, to make access easier.
-
Page 12: Maintenance
You will need a selection of small hand tools, screwdrivers, spanners etc. to carry out this procedure. Our Service Department can arrange for an Engineer to do the conversion for you but a charge will be made. Door Reversal WARNING: Switch off electrical supply and pull out the mains plug. Remove loose items/fittings from inside the fridge and place food into insulated containers whilst carrying out this operation. -
Page 13: Troubleshooting
3. See ‘Defrosting’ in the CLEANING & MAINTENANCE section for advice. If there is still a problem contact Hotpoint Service (See KEY CONTACTS, back page, for contact details). OPERATING SOUNDS OF A FRIDGE These are the normal types of sound that... -
Page 14: Hotpoint Guarantee
All Hotpoint appliances carry a fully inclusive 12 month parts and labour guarantee as well as free replacement parts for the first 5 years (except microwaves, selected integrated appliances and cooker hoods, which have a one year guarantee) provided that they are fitted by a Hotpoint engineer. -
Page 15: After Sales Service
Hotpoint appliance than us - the manufacturer” As part of our commitment to you, all Hotpoint appliances have the added benefit of a fully inclusive parts and labour guarantee for the first 12 months. In addition to this you also have the advantage of free replacement parts for the first 5 years when fitted by a Hotpoint engineer. -
Page 16: Key Contacts
Monday to Sunday, 8am to 8pm www.hotpointservice.co.uk Republic of Ireland: 1850 502 200 Genuine Parts and Accessories UK: 08709 077 077 Monday to Friday, 8.30am to 5pm Saturday, 8.30am to 12noon www.hotpointservice.co.uk Republic of Ireland: (01) 842 6836 www.hotpoint.co.uk 01/2005 195045106.01...