Removable Warming Drawer - LG LRG3097ST User Manual

CA R E A N D C L E A N I N G O F T H E R A N G E

REMOVABLE WARMING DRAWER

NOTE: Before performing any adjustments, cleaning
or service, unplug the range.
Make sure the warming drawer heating element is
cool.
Most cleaning can be done with the drawer in place.
However, the drawer may be removed if further
cleaning is needed. Use soap and warm water to
thoroughly clean.
TO REMOVE THE DRAWER:
Open the drawer to the fully opened position.
Remove the 2 screws (right and left sides). (refer
to the illustration as below)
Locate glide lever on each side of drawer, push
down on the left glide lever and pull up on the right
glide lever.
Pull the Warming Drawer away from the range.
TO REPLACE THE DRAWER:
Pull the bearing glides to the front of the chassis
glide.
Align the glide on each side of the drawer with the
glide slots on the range.
Push the drawer into the range until levers "click"
(approximately 2 inch). Pull the drawer open again
to seat bearing glides into position.
If you do not hear the levers "click" or the
bearing glides do not feel seated remove the
drawer and repeat steps 2-4.
This will minimize possible damage to the bearing
glides.
Replace the two screws.
44
Remove screw
Lever
Lever
Push down with finger Pull up with finger