Procedure For Hardware Installation; Hardware Requirements; Decide Where To Place Your Adsl2+ Modem; Setup Lan Connection - Sitecom DC-227 Full Manual

Sitecom ADSL2+ Modem DC-227

2.2 Procedure for Hardware Installation

2.2.1

Hardware Requirements

ADSL/ADSL2/ADSL2+ Internet subscription
•
9V AC power adapter
•
RJ-45 Ethernet cable
•
RJ-11 ADSL line
•
2.2.2

Decide where to place your ADSL2+ Modem

You can place your ADSL2+ Modem on a desk or other flat surface, or you can mount it
on a wall. This location must be close to a power connection and your ADSL/Telephone
connection.
2.2.3

Setup LAN connection

Connect an Ethernet cable to one of your computers.
2.2.4

Hardware Setup Procedures

1. Connect the RJ-11 cable from the DC-227 to your ADSL line.
2. Connect the RJ-45 line from your PC to an Ethernet port on the DC-227.
3. Plug the power supply into a wall outlet.
2.2.5

Power on

Connect the power-adapter to the power inlet port and connect it to a wall outlet, this
product will automatically enter the self-test phase. When it is in the self-test phase, the
Power LED will not be lighted for about 15 seconds, and then Power will flash 9 times to
indicate that the self-test operation has finished. Finally, power will be lit continuously to
indicate that this product is in normal operation.
8