Parallel Port - Gigabyte GA-P61A-D3 User Manual

& EHCI Hand-off
Determines whether to enable EHCI Hand-off feature for an operating system without EHCI Hand-off
support. (Default: Disabled)
& Port 60/64 Emulation
Enables or disables emulation of I/O ports 64h and 60h. This should be enabled for full legacy support
for USB keyboards/mice in MS-DOS or in operating system that does not natively support USB devices.
(Default: Disabled)
& USB Storage Devices
Displays a list of connected USB mass storage devices. This item appears only when a USB storage device
is installed. (Default: Auto)
& OnBoard USB3.0 Controller
Enables or disables the USB 3.0 controller. (Default: Enabled)
& OnBoard LAN Controller
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
` Super IO Configuration
This section provides information on the super I/O chip and allows you to configure the serial port and

parallel port.

& Serial Port A
Enables or disables the onboard serial port. (Default: Enabled)
& Parallel Port
Enables or disables the onboard parallel port. (Default: Enabled)
& Device Mode
This item is configurable only when Parallel Port is set to Enabled. Selects an operating mode for the
onboard parallel (LPT) port. Options are: Standard Parallel Port Mode (Default), EPP Mode (Enhanced
Parallel Port), ECP Mode (Extended Capabilities Port), EPP Mode & ECP Mode.
` Intel(R) Smart Connect Technology
& ISCT Support
Enables or disables Intel
®
` Marvell SATA Controller Configuration
& GSATA Controller (Marvell
Enables or disables RAID for the SATA controllers integrated in the Marvell
the SATA controllers to AHCI mode. The area below displays the current status of the two SATA ports.
Disables this function.
Disabled
IDE Mode D isables RAID for the SATA controllers and configures the SATA controllers to IDE
mode.
RAID Mode Enables RAID for the SATA controllers.
AHCI Mode C onfigures the SATA controllers to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug. (Default)
Smart Connect Technology. (Default: Disabled)
88SE9172 Chip, GSATA3 4 and GSATA3 5 connectors)
®
- 26 -
88SE9172 chip or configures
®