Advertisement
Available languages
Available languages
• Place Base Extensions
(A) as illustrated and
snap Base Connector (B)
firmly onto Base
Extensions (Fig. 1).
• Insert the Adjustable
Pole (C) into the Base by
lining up the recessed
slot in the Pole to the
Fig. 1
B
• Place the Motor
Assembly (E) onto the
Adjustable Pole and
screw into place by
turning Clockwise (Fig.
4). Align the slot to slide
the latch into place (Fig.
5). NOTE: The tilt angle
of the Motor Assembly
can be changed by
simply tilting the Motor
up or down.
• Remove the Blade
Knob (F) and the Rear
Grille Mounting Nut (G).
Place the Rear Grille (H)
raised dot on the Base
Connector and push in.
Be sure that the Pole is
fully seated. Hold the
Base firmly and twist the
Pole CLOCKWISE 90°
until it stops. DO NOT
OVER-TIGHTEN (Fig. 2).
Fig. 2
A
ATTACHING THE MOTOR ASSEMBLY
onto theMotor Housing
by making sure the 3
holes of the Rear Grille
fit over the 3 bumps on
Tighten the Rear Grille
Mounting Nut
CLOCKWISE. (Fig. 6)
Fig. 4
F
ASSEMBLY INSTRUCTIONS
• Adjust to the desired
height and tighten the
Height Adjustment Knob
(D) (Fig. 3).
Fig. 3
C
E
Fig. 6
G
D
HEIGHT
Fig. 5
H
Advertisement
