Moving The Unit; Troubleshooting - Omega Skyline Relaxation Operation Manual

Moving the Unit
CAUTION
• Do not move the unit while someone is sitting on it. Do not place objects on or sit, climb, or stand on the calfrest.
Lifting and Moving the Unit
Always use two persons to lift the unit. Use one person on the left and one person on the right to carefully
move the unit, see the picture below.
• Hold onto to the armrest tightly to prevent damage to the unit and the floor.
TROUBLESHOOTING
The following sounds are perfectly normal and will not have any effect on the operation of the unit:
• Sound of the armrest and back cushion rubbing against other objects during recline.
• Sound of Tapping.
• Sound when the unit is at Standby Mode by flipping the Power Switch to On.
• Sound when sitting down.
• Sound of air being pumped in during an Air Pressure Massage.
• Sound of air being released during an Air Pressure Massage.
• Deep Vibration sounds during Vibration Massage.
• Rattling sound of the calfrest.
Problem
Probh
Not working when
plugged in.
The unit makes a humming
sound or clip clop clip clop
noise during operation.
You may notice an increase
in noise during a session.
Possible Re<
-The power switch is off.
- The lock switch is off.
-Power plug is not properly connected
with the outlet.
-The fuse is blown.
Sounds are made by the air pump,
the electrical parts and the
mechanical parts.
The unit has been used over its
time limit.
The unit stops working suddenly. Timeout.
Solutioi
-Turn on the power switch.
-Turn on the lock switch.
-Reconnect the power plug
with the outlet.
-Replace the fuse with
the same specifications.
The sounds are normal. No need
for maintenance.
Shut down the unit and turn it
back on after a half an hour.
Shut down the unit and turn it back
on after a half an hour.