Omega Skyline Relaxation Operation Manual page 7

Adjusting the Calfrest and Backrest
1 - Turn the unit to the Standby Mode by plugging in the Power Plug,
turning on the Lock Switch and the Power Switch.
2 - Press to adjust the angle of the backrest and calfrest.
Adjusting the Pillow Position
CAUTION
Always unplug the unit before cleaning it. Never touch
the power plug with wet hands.
- Failure to follow these instructions may lead to electrocution or burns.
Cleaning The Upholstery
Wipe these areas with a soft, dry cloth. (Do NOT use cloths containing any kind of chemical, etc).
If the upholstery is particularly dirty, please:
l.Soak a soft cloth in water or a 3% - 5% solution of mild detergent, wring it out thoroughly;
2.Wipe the surface with the wetted cloth;
3.Next, rinse the cloth in water, wring it out thoroughly and then wipe any remaining
detergent from the surface;
4.Wipe the surfaces with a soft dry cloth;
S.AIlow them to dry naturally. (Do NOT use a hair dryer to dry the surfaces).
Do not allow these areas to get in touch with plastic for extended periods of time as it
may lead to discoloration.
Please do NOT use paint thinners, benzene, or alcohol to clean the surface.
Cleaning Remote Panel and Wood Chair Back
Wipe the unit with a cloth that has been soaked in a mild detergent and thoroughly wrung out.
Next, wipe the unit with a cloth that has been moistened with water only and thoroughly wrung out.
Make sure you thoroughly wring out the cloth first when cleaning the control panel.
Allow the unit to dry naturally.
Please do NOT use thinners, benzene or alcohol to clean the surface.