Settings For The Digital Recorder; Digital Recorder - Continuous Operation On/Off; Setting Recording Capacity/Quality; Setting Maximum Time Shift - Loewe Digital Recorder + Operating Instructions Manual

Settings for the Digital Recorder

You can use the Digital Recorder with the values set at the factory initially.
In this case, please continue reading on page 9.
However, you should change the settings later to adjust the Digital Re-
corder to meet your own requirements. In the process, you can determine
the recording quality and the recording capacity of the hard disk for
analogue TV signals, you can set the Digital Recorder continuous operation
for viewing with a time shift, the maximum time shift, the jump distance,
Smart jump and the serial recording tolerance.
You can adjust the settings in the Digital Recorder menu, which is a sub-
menu of the DR archive.
Call the archive with the red coloured key. In case of a
TV set with MHEG-5 use the key
archive.
DR archive
27.08. 3Sat AVO-Session Basel 2002
28.08. ARD Fußball-WM Deutschland-Polen
21:30 - 22:00 Kultursendung
Detail
TEXT OK
P+
Page /
P–
Call the Digital Recorder menu with the MENU button.
Digital Recorder menu
DR continuous operation
on
Switching Digital Recorder continuous operation on/off
Recording takes place on a constant basis with the Digital Recorder contin-
uous operation "on". You can then watch TV with a time shift at any time.
Only archive recordings and archive playback are possible in the "off"
mode.
The factory default setting is the "on" mode.
Mark "Digital Recorder continuous operation".
OK
For the setting, mark the menu line below.
OK
Digital Recorder menu
DR continuous operation
on
Select "on" or "off".
OK
for calling the DR
free capacity 49:42 hrs
View Edit/protect
Delete/copy
Sort alphabetically
INFO
Recording quality Maximum time shift Inf
...
INFO
off

Setting recording capacity/quality

For signals from analogue terrestrial/cable stations, set the recording quality
to very high, high, medium or standard. Signals from DVB stations are
recorded directly, and therefore always at high quality. In the list above, you
can see the recording capacity still available for the Digital Recorder (call up
with the INFO button if necessary). Select a higher quality if you intend to
copy the programme to a VCR or DVD recorder.
The factory default setting for the recording quality is "high".
Mark the "Recording quality".
OK
For the setting, mark the menu line below.
OK
Recording quality
To record analogue stations you can set the recording qualtity,
which alters the recording capacity. The following applies if
recordings are only made from analogue sources:
Foe recording quality:
very high
high
medium
standard
OK
y high
END
INFO
Select the recording quality.
MENU
OK

Setting maximum time shift

This time indicates the maximum possible time between the time shift
END
picture and the live picture without losing any of the programme. It may be
between 30 minutes and 2 hours. The factory default setting is "60 min".
You can trace the programme back for this time. If you stop the pro-
gramme for longer than the set time, the TV set switched to the playback
mode.
Mark "Maximum time shift".
OK
For the setting, mark the menu line below.
OK
30 min
Select the time.
OK
END
remaining recording capacity:
approx. 13:50 hrs.
approx. 21:50 hrs.
approx. 32:50 hrs.
approx. 65:40 hrs.
Digital Recorder menu
Recording quality
high medium standard
Digital Recorder menu
Maximum time shift
60 min 90 min 120 min
END
INFO
very
INFO END
7 -