Setting Up The Answering System; Listening To Incoming Messages - Oricom AM900 User Manual

Operation

Setting up the answering system

On the rear of the answering system you will find a slide switch with
which you can set to select how many times the phone rings before
incoming calls are answered.
2 The call will be answered after 2 rings.
6 The call will be answered after 6 rings.
TS In Toll Saver mode incoming calls are answered after six rings until
the first new message has been recorded. Once a message has been
recorded the answering system will answer.
NOTE:
The Toll Saver function enables the user to check remotely for new
messages without incurring a call charge.
General operation
The answering system can be switched off (standby) or on using the
button. If the answering system is switched off, the display
shows the message and no messages will be recorded.
The maximum length for incoming messages is 120 seconds. If the
caller speaks for longer, a signal tone sounds and the call will be cut
off. If there is a pause of more than 7 seconds during recording, the
call is automatically terminated with a signal tone. No more calls will be
answered if the memory capacity for new messages is exhausted and the
message FL will appear in the display.

Listening to incoming messages

The integral speaker makes it possible to listen to incoming calls without
speaking to the caller (sometimes called "Call Screening"). If you do
not want to listen in to the incoming calls, set the volume right down by
repeatedly pressing the  arrow button.
10