Repair - Scotsman DCE33 User Manual

DCE33

REPAIR

Spray Pump
The water pump that forces the water from the
reservoir through the spray jets.
1. Disconnect electrical power.
2. Open the bin door and locate the three hoses
connected to the water pump.
A. Loosen the hose clamps from the pump hoses.
B. Remove the pump hoses from their
connections.
3. Disconnect water and drain tubes.
Spray Pump
(for reference)
Reservoir
(for reference)
4. Carefully pull machine out from its installed
location to expose the back panel.
5. Remove the back panel.
6. Disconnect wires from the top of the pump
motor.
7. Remove two screws holding pump to bin, and
remove the pump from the ice machine.
8. Reverse the above steps to re-assemble.
Electrical Shock Hazard
Disconnect Electrical
Power Before Beginning
Removal of Parts
Pump Hose Removal
Suction
Hose Clamp
Hose
September 2011
Spray Jets
Spray Jets are small nozzles that are under the
freezing surface, they spray a narrow pattern of
water at the freezing surface. If plugged or
restricted, poorly shaped ice cubes will form.
If the spray jets are removed the o-rings between
the water inlet tube and the spray jet bases must
be in place (see illustration).
Cap
Spinner
Jet Base
O-Ring
Pump
Discharge
Page 26
Curtain
Curtain Stiffener
Reservoir
Body
O-Ring
Back view of
Reservoir
Cube
Chute