Advertisement
Mini-Box.com
ATX DC-DC Converter Series
The PICOPSU-90 has been specifically designed for the Mini-ITX
form factor, thus eliminating the need for ATX power cables. It is
also 1U compliant – height will not exceed 1U form factor.
1) After the picoPSU module was 'snapped in', hook the hard drive
power or floppy power to your floppy/hard drives. If more hard
drives or floppy connectors are needed, use a HDD/floppy "Y"
splitter cable.
PicoPSu-90 shown with the D201GLY Intel Motherboard.
2) Connect a 12 VDC power adapter (or any 12V source) to the
DC-to-DC connector, center pin / white wire is positive (+).
3) Turn on the PC using the motherboard ON/OFF motherboard
switch
Typical configuration
The picoPSU-90 has been tested with all mini-ITX board (VIA C3,
VIA C7, low power AMD, Celeron, Core Solo and Atom) under
virtually any disk / floppy / CDROM / PCI configuration. Additionally,
the PICOPSU-90 can power P4 boards equipped with an 12VATX
4 pin connector. NOTE: The hard drive cable harness can be
picoPSU-90 Quick Installation Guide
Page 2
Advertisement
