Pico Communications PICOPSU-90 Quick Installation Manual

picoPSU-90
12V, 90Watt ATX Power Supply
Quick Installation Guide
Version 1.0d
P/N picoPSU-90
Introduction
Based on the electrical design of the picoPSU-120, the picoPSU-90 is a small yet
powerful and fully compliant ATX power supply designed to power a wide variety
of motherboard from a single 12V regulated power source.
The PICOPSU-90 is the only snap power supply solution for general purpose
motherboards. Compatible with an entire range of mini-ITX, UATX or full size
ATX motherboards the picoPSU-90 provides cool, silent power for system. The
PICOPSU-90 has many advantages over a regular power supply:
-Smallest ATX PSU to date
-100% silent operation
-Low heat dissipation with efficiency over 95%
-Plugs directly into the motherboard's power connector, no cable mess
Quick installation Instructions
The PICOPSU-90 has been specifically designed for the Mini-ITX form factor,
thus eliminating the need for ATX power cables. It is also 1U compliant – height
will not exceed 1U form factor.
1) After the picoPSU module was 'snapped in', hook the hard drive power or
floppy power to your floppy/hard drives. If more hard drives or floppy connectors
are needed, use a HDD/floppy "Y" splitter cable.