Summary of Contents for Pico Communications PSU-90
Page 1
picoPSU-90 12V, 90Watt ATX Power Supply Quick Installation Guide Version 1.0c P/N picoPSU-90 Introduction Based on the electrical design of the picoPSU-120, the picoPSU-90 is a small yet powerful and fully compliant ATX power supply designed to power a wide variety of motherboard from a single 12V regulated power source.
Page 2
Mini-Box.com ATX DC-DC Converter Series The PICOPSU-90 has been specifically designed for the Mini-ITX form factor, thus eliminating the need for ATX power cables. It is also 1U compliant – height will not exceed 1U form factor. 1) After the picoPSU module was ‘snapped in’, hook the hard drive power or floppy power to your floppy/hard drives.
Page 3
Mini-Box.com ATX DC-DC Converter Series disconnected in case the user does not need any peripheral. Additionally, the cable harness can be made to any length or output connector type provided that the max load does not exceed 6A for GND return. Please look under specifications for the mating connector type.
Page 4
Mini-Box.com ATX DC-DC Converter Series Header and mating connector for the removable cable harness can be found at: http://www.jst-mfg.com/product/pdf/eEH.pdf Overload protection Over load protection will be effected when either of the loads (+5V & +3.3V) exceeds > 200% Max Load. Turn-on Delay After turning on, at least 20 ms will be needed for the rise of +5VSB output voltage (measured from 10% to 95%) to reach its peak.