Advertisement
port forwarding – 2 wire router
The port forwarding process may vary depending on the brand and model number of the router
being used. Port forwarding of a router is required to allow user access to your network device.
Regardless of the 2 Wire Router being used, the process of port forwarding is similar. You will
need to enable the ports by locating the port range forwarding screen (Note: in many 2 wire sys-
tems, it is located in the firewall setting). The set up instruction outlined below is an example of
port forwarding a 2 Wire Router using 2 Wire Model 1800G.
Step 1:
Open your web browser.
Enter the router IP address 192.168.1.254 in the address bar as shown below, followed by pressing
Enter.
http://192.168.1.254
Step 2:
Select the Firewall Tab.
Page 31
Information in this document is subject to change without notice. As our products are subject to continuous improvement, Lorex Technology and our subsidiaries
reserve the right to modify product design, specifications and prices, without notice and without incurring any obligation. E&OE © 2006 LOREX. All rights reserved.
A Guide to Port Forwarding Your Router
Source: Portforwarding.com
WWW.LOREXCCTV.COM
Advertisement
