Handset Battery Charging - VTech DS6671-2 User Manual

Getting started

Handset battery charging

Once you have installed the battery, the handset LCD display indicates the battery
status (see the table below).
NOTES
• For best performance, keep the handset in the telephone base or charger when not in use.
• The battery is fully charged after 12 hours of continuous charging.
• If you place the handset in the telephone base or the charger without plugging in the
battery, the screen displays No battery.
Battery indicators
The screen is blank, or
displays Place in charger
and flashes.
The screen displays
Low battery and
The screen displays
HANDSET X.
When it is fully charged, you can expect the following performance:
While in handset use (talking*)
While in speakerphone mode (talking*)
While not in use (standby**)
* Operating times vary depending on your actual use and the age of the battery.
** Handset is not charging or in use.
After you install your telephone or power returns following a power
outage, the handset will prompt you to set the date and time.
For instructions, see Set date and time on page 31.
To skip setting, press CANCEL.
The battery has no or very
little charge. The handset
cannot be used.
The battery has enough
flashes. charge to be used for a
short time.
The battery is charged.
Operation
Battery status
Seven hours
Three hours
Five days
4
Action
Charge without interruption
(about 30 minutes).
Charge without interruption
(about 30 minutes).
To keep the battery charged,
place it in the telephone
base or handset charger
when not in use.
Operating time
SET DATE
MM/DD/YY