Case Led Connection; Case Open Alarm Connection; Usb 2.0 & Ieee 1394 Firewire Connection - Thermaltake VE1000SWA Manual

3.2 Case LED Connection

On the front of the case, you can find some LEDs and switch leads
(POWER SW*1, POWER LED*1, H.D.D. LED*1, RESET SW*1)
Please consult user manual of your motherboard manufacturer, then
connect these leads to the panel header on the motherboard. These
leads are usually labeled; if not, please trace them back to the case
front to find out their source.
- POWER LED connects to your M/B at the PLED
- POWER SW connects to the PWR connector on the motherboard.
- H.D.D LED connects to the eSATA connector shown as picture(3.5)
- RESET SW connects to the RSW connector on the motherboard,

3.3 Case Open Alarm Connection

To find out the cable with 2pin
1
connector ("Micro SW") from the
rear of inside the chassis.
To find out the position of Chassis
2
Alarm on your motherboard.
(please consult your motherboard
manual)
13
3.4 USB 2.0 & IEEE 1394 Firewire Connection
USB connection
Please consult your motherboard manual to find
out the section of "USB connection".
White Wire
Black Wire
USB2.0
( Brank )
GND1 GND2
Data+1 Data+2
Data-1 Data-2
Vcc1 Vcc2
14