Table of Contents
Advertisement
Others
Before Calling Service Personnel
Check the following guide for the possible cause of a problem before contacting service.
Symptoms and correction
Symptom
Cause
No power.
• The power plug is disconnected.
The DVD player turned off by
• The automatic power off function turned the
itself.
unit off.
No picture or abnormal color
• The TV is not set to receive DVD signal
(pinkish, greenish, etc.).
output.
• The video/HDMI cable is not connected
securely.
• Mismatch setting between TV and this unit.
• Wrong connection.
• PROGRESSIVE button is pressed on a TV
equipped with component video input jacks but
does not support progressive scan.
No sound.
• The equipment connected with the audio cable
is not set to receive DVD signal output.
• The audio cable is not connected securely.
• The audio receiver or TV is turned off.
• The setting of output sound format is
incorrect.
The playback picture has
• The disc is dirty.
occasional distortion.
• It is in fast forward or fast reverse playback.
Brightness is unstable or noises
• The effect of copy protection.
are present in the playback
pictures.
The DVD player does not start
• No disc is inserted.
playback.
• An unplayable disc is inserted.
• The disc is placed upside down.
• The disc is not placed within the guide.
• The disc is dirty.
• The parental lock function is set.
Playback does not follow the
• It is in the mode of repeat playback, memory
course of the disc's program.
playback, etc.
Buttons do not work.
• Power supply fluctuations or other
abnormalities such as static electricity may
interrupt correct operations.
The remote control does not
• The remote control is not pointed at the
work properly.
remote sensor of the DVD player.
• The remote control is too far from the DVD player.
• The batteries in the remote control are
exhausted.
36
Correction
Page
• Connect the power plug securely into the
11-12
wall outlet.
• Press the PLAY button.
• Select the appropriate video input mode on
the TV so the picture from the DVD player
appears on the TV screen.
• Connect the video/HDMI cable securely into
11-12
the appropriate jacks.
• Select the correct Video Output setting.
• Check the connection.
11-12
• Toggle PROGRESSIVE button to turn off
progressive mode.
• Select the correct input mode of the audio
receiver so you can listen to the sound from
the DVD player.
• Connect the audio cable securely into the
11-15
appropriate jacks.
• Turn on the equipment connected with the
audio cable.
• Select the proper audio setting.
• Remove the disc and clean it.
• Sometimes a small amount of picture
distortion may appear. This is not a
malfunction.
• Connect the DVD player directly to the TV.
Avoid connecting the DVD player to a VCR or
TV/VCR combination.
• Insert a disc.
• Insert a playable disc. (Check the disc type
and color system.)
• Place the disc with the playback side down.
• Place the disc correctly inside the guide on
the disc tray.
• Clean the disc.
• Cancel the parental lock function or change
the parental lock level.
• These operations may prevent a proper
progress of the contents.
• Press and hold the ON/STANDBY button on
the front panel for more than about 3
seconds. The DVD player turns off. Press the
button again to turn it on. If the buttons still do
not work, disconnect the power plug and insert
it into the wall outlet again.
• Point the remote control at the remote sensor of
the DVD player.
• Operate the remote control within about 7 m.
• Replace the batteries with new ones.
16
16
3 1
1 2
16
16
3 2
5
-
1 1
16
6
16
16
5
32
-
-
1 0
1 0
1 0
Advertisement
Table of Contents
