7. Install the card reader retainer on the side of the new card reader.
Figure 21. Installing the card reader retainer
8. Slide the new card reader into the drive bay until it snaps into position.
Figure 22. Installing the card reader
9. Reconnect the card reader cable to the front USB connector on the system board. See "Locating
parts on the system board" on page 78.
10. Reinstall the front bezel. See "Removing and reinstalling the front bezel" on page 83.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 117.
.
Chapter 10
Replacing FRUs
93