Detaching The Front Panel - Kenwood DNN9250DAB Instruction Manual

ñ
D
etaching The Front Panel
You can detach the front panel to prevent
theft.
DNN9250DAB/ DNR8025BT
1
Press the <0> button for
1 second to open the front panel.
0
NOTE
• You can set the front panel to open automatically
when the ignition is turned off. See
angle control (P.128).
2
Detach the panel as the diagrams
below.
1
NOTE
• The attaching plate closes automatically in about
10 seconds after the front panel is released.
Remove the panel before this happens.
Monitor
3
2
4
Return to the Top page
ö After detaching:
Put the panel in the protective bag
supplied with the unit.
NOTE
• When detaching a part of the front panel, detach
it toward the front side as shown in the diagram
above. If it is detached upward, the front panel
will be broken.
• To prevent deterioration, do not touch the
terminals of the unit and faceplate with your
fingers.
• If the terminals on the unit or faceplate get dirty,
wipe them with a clean soft dry cloth.
DNN6250DAB
1
Slide the Release key upward to
detach the part of the front panel.
Then, detach the panel as the
diagrams below.
1
2
Basic Operations
Continued
19