Connections; Connecting An Antenna - Magnavox TB100MW9 Owner's Manual

Basic Connection:
When Connecting to Cable Box (optional) Also:
VHF/UHF
antenna
RF cable
Supplied cables used in this connection are as follows:
RF cable x1
•
Please purchase the rest of the necessary cables at your local store.
Before connecting, ensure the AC power cords of all devices are NOT
connected to the AC outlets.
1 Use an RF cable to connect the antenna to the ANT. IN jack on the
STB.
2 Use an RF cable to connect the incoming cable to the antenna
input jack on the cable box.
3 Use an RF cable to connect the antenna output jack on the cable
box to the antenna input jack on the TV.
4 Refer to "Connecting to TV" on page 10 to connect your TV.
NOTE:
When you connect the RF cable to another device, be sure to use a splitter as shown below.
•
VHF/UHF
antenna
Splitter
X6040UD_Book.indb 9 X6040UD_Book.indb 9

Connecting an Antenna

AUDIO OUT VIDEO
R L OUT
Incoming cable
signals
Cable box (optional)
ANT
RF cable
IN
AUDIO OUT VIDEO
R L OUT
Another device
To RF-IN
e.g., VCR
To ANT. IN
VHF/UHF
antenna
RF cable Rear panel of STB
ANT. IN ANT. ΟUΤ
To antenna
ANT
input jack
OUT
RF cable
Rear panel of STB
ANT. IN ANT. ΟUΤ
Note to the Cable TV System
Installer:
This reminder is provided to call
the Cable TV system installer's
attention to Article 820-40 of
the National Electrical Code,
which provides guidelines for
proper grounding - in particular,
specifying that the cable ground
shall be connected to the
grounding system of the building,
as close to the point of cable entry
as possible.
STB

CONNECTIONS

To audio/video input
jacks of the TV
Refer to following
pages for the
connection to TV.
9
EN
1A23
10/22/2007 5:09:12 PM 10/22/2007 5:09:12 PM