BEFORE USING The serial number of this product may be found on the bottom of the unit. You should record the number and other vital information here and retain this book as a permanent record. Serial numbers are not kept on file. Date of Purchase Dealer Phone No.
Page 3
BEFORE USING F IGURE A EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECT RICAL CODE ANTE NNA L EAD I N W I R E GROUND C L A M P A NTENNA DI SCHARG E UN I T (NEC SECTION 8 10 -2 0) EL ECT RI C SE RV I CE EQ U I PM EN T...
BEFORE USING Precautions Location IMPORTANT COPYRIGHT INFORMATION For safe operation and satisfactory performance of Unauthorized recording or use of broadcast televi- this product, keep the following in mind when select- sion programming, video tape, film or other copy- ing a place for its installation: righted material may violate applicable copyright Shield it from direct sunlight and keep it away •...
All rights reserved. No part of this manual may be reproduced, copied, transmitted, disseminated, transcribed, downloaded or stored in any storage medium, in any form or for any purpose without the express prior written consent of Funai. Furthermore, any unauthorized commercial distribution of this manual or any revision hereto is strictly prohibited.
BEFORE USING Information on Digital Broadcasting ATSC Receives ATSC Digital terrestrial signals Digital terrestrial antenna (Set Top Box) Digital broadcasting is the most advanced format of broadcasting, employing a new technology for compression of audio and video signals which allows broadcasters to transmit digital signals using existing terrestrial systems.
BEFORE USING Location of Controls 1 STANDBY-ON button: Turns STB on and off. Remote Control 2 Number buttons: Input channel numbers and passwords. STANDBY-ON 3 SETUP button: Enters or quits “SETUP” menu. СH + 4 STILL button: Pause the image while you continue to listen to the audio. СH - 5 Navigation buttons / s / B :...
BEFORE USING Accessories Installing Batteries Check the following accessories when unpacking the STB: 1 Unsnap the battery cover from the back of the remote control. Remote control: NA383UD STANDBY-ON СH + СH - ALT.CH DISPLAY SETUP STILL AUDIO RETURN 2 Install two AA batteries making sure the polarity (+ / -) is correct.
CONNECTIONS Connecting to TV Rear panel of STB AUDIO OUT VIDEO ANT. IN ANT. ΟUΤ To audio input jacks (L, R) Video cable RF cable Audio cable AND/OR To video input jack To antenna input jack Supplied cables used in this connection are as follows: RF cable x1 •...
OTHER CONNECTIONS STB Connection to a Standard Stereo System Rear panel of STB AUDIO OUT VIDEO ANT. IN ANT. ΟUΤ STEREO COMPONENT Audio cable To audio input jacks (L, R) Supplied cables used in this connection are as follows: RF cable x1 •...
OTHER CONNECTIONS Connecting to TV and Video Devices (VCR, DVD Recorder, etc) e.g.: Connection to DVD Recorder Rear panel of STB AUDIO OUT VIDEO ANT. IN ANT. ΟUΤ Video cable To audio input jacks (L, R) Audio cable Audio cable Video cable DVD Recorder To video input jack...
INITIAL SETUP (SETUP WIZARD) Initial Setup 5 Select the connection for audio output using [ ], then press [OK]. s / B Setup Wizard SETUP WIZARD 2/6 When STB is turned on for the first time or before completing autoscan, “SETUP WIZARD” is Select the connection for Audio output.
Page 14
INITIAL SETUP (SETUP WIZARD) 9 Select “AUTOSCAN” using [K then press [OK]. The system is now scanning AUTOSCAN will rescan all channels. This may take a while to complete. Channel Found EXIT AUTOSCAN EXIT STB starts receiving available digital channels •...
BASIC OPERATION NOTE: Selecting Channels on the STB If you do not have a particular sub-channel number • you want to select, enter the main channel number About Sub-channel Broadcasting and then press [OK]. (If the main channel number Digital broadcasting offers a service that enables is 1digit, you should press [OK] twice.) The STB multiple signals, called “sub-channels”, to be sent automatically tunes in to the lowest sub-channel for...
BASIC OPERATION Choosing Audio Language Electronic Program Guide (EPG) You can change languages when the channel provides Electronic Program Guide (EPG) is the electronic alternate languages. equivalent of a printed TV program guide. You can view a list of programs scheduled for the next few hours.
ADVANCED OPERATION Adding/Deleting Channels 5 Press [OK] again to add the channel to the channel map. Add or delete desired channels in the channel map. E.g., adding channel 6 CAUTION: You cannot recover the deleted channels once they • (or leave for a few seconds) are deleted unless you perform the autoscan again.
ADVANCED OPERATION 5 Select the channel number you want to 5 Adjust the antenna’s direction to get delete from the channel list on the right the best reception. using [K L], then press [OK]. • A status bar stretches to the right according to the signal strength.
ADVANCED OPERATION 4 Select “AUTOSCAN” using [K L], then 3 Select “DISPLAY MODE” using [K press [OK]. then press [OK]. AUTOSCAN AUTOSCAN DETAIL The system is now scanning EXIT EXIT AUTOSCAN will rescan all channels. V-CHIP This may take a while to complete. CHANNEL CHANNEL CLOSED CAPTION...
ADVANCED OPERATION Time Zone INFORMATION on Display Mode For standard 4:3 TVs displaying widescreen 3 Select “TIME ZONE” using [K L], then 16:9 broadcasts, your choices are: press [OK]. TIME EXIT TIME ZONE EASTERN CHANNEL D.S.T TIME DETAIL 4:3 TV screen 16:9 broadcast INITIAL LETTERBOX...
ADVANCED OPERATION See the following description for setting each V-Chip Options item. V-CHIP V-chip reads the ratings for programs, then denies EXIT access to the programs which exceed the rating level MPAA RATING CHANNEL TV RATING you set. With this function, you can block certain TIME DOWNLOADABLE RATING CLEAR DOWNLOADABLE RATING...
Page 22
ADVANCED OPERATION Rating Category 7 Press [SETUP] to exit “SETUP” menu. Mature audience only higher NC-17 No one under 17 admitted To Set the Sub Ratings Restricted; under 17 requires As for TV-MA, TV-14, TV-PG, or TV-Y7, you accompanying parent or adult can further set the sub ratings to block specific guardian elements of programming.
ADVANCED OPERATION 3 Enter the new 4-digit password using 5 Select the desired DTV closed caption the number buttons. using [K L], then press [OK]. • Enter password again in “Confirm password.” Select service. entry field. SERVICE1 SERVICE2 V-CHIP SERVICE3 SERVICE4 EXIT SERVICE5...
ADVANCED OPERATION [Back Color] CC Style Edit Background color of the displayed caption can be You can edit the style of CC such as font, color or switched. size, etc. This feature is available only when “CC [Back Opacity] STYLE” is set to “MANUAL”. Background opacity of the displayed caption can be switched.
OTHERS Troubleshooting Before requesting service for this STB, check the table below for a possible cause of the problem you are experiencing. Some simple checks or a minor adjustment on your part may eliminate the problem and restore proper operation. Symptom Remedy •...
OTHERS Symptom Remedy When you forget the • If you forget the password, refer to “New Password” on page 22. password for v-chip Closed captioning • Change the TV setting to a mode other than VIDEO. • Change channels through the TV. display (TEXT mode) •...
GUÍA PARA RÁPIDA CONSULTA Antes de utilizar 2 Instale dos pilas AA asegurándose que la polaridad (+ / -) sea la correcta. Ubicación del control Mando a distancia STANDBY-ON СH + NOTA: СH - • Cuando cambie las pilas, hágalo por pares. ALT.CH DISPLAY SETUP...
GUÍA PARA RÁPIDA CONSULTA Antena de Conexiones VHF/UHF Otro dispositivo A RF-IN ejemplo, VCR Divisor Conexión a una antena A ANT. IN Conexión básica: Antena de Conexión a TV VHF/UHF Panel trasero del STB Cable de RF Panel trasero del STB AUDIO OUT VIDEO ANT.
GUÍA PARA RÁPIDA CONSULTA Conexión STB a un sistema Los cables provistos utilizados en eseta conexión son los siguientes: estéreo normal Cable de RF x 1 • Adquiera el resto de los cables necesarios en una Panel trasero del STB tienda de su zona.
Page 30
GUÍA PARA RÁPIDA CONSULTA Para cancelar durante la exploración: 2 Conecte la alimentación del STB utilizando Presione [OK]. el [STANDBY-ON] y aparece “SETUP WIZARD”. NOTA: Si se cancela la exploración automática, es posible • NOTA: que no se reciban algunos canales que aún no Demora unos 8 segundos en aparecer el “SETUP •...
LIMITED WARRANTY FUNAI CORP. will repair this product, free of charge in the USA in the event of defect in materials or workmanship as follows: DURATION: PARTS: FUNAI CORP. will provide parts to replace defective parts without charge for one (1) year from the date of original retail purchase.